Brake Cable Pull Front Puch Maxi Black – Including Adjustment Screws

Safety comes first – and that starts with a reliable brake. If your old brake cable is stiff or shows signs of fraying, it’s high time for a replacement. Our brake cable pull for the front wheel of your Puch Maxi comes in a classic, subtle black and integrates perfectly into the look of your handlebars. What’s special about this set: the matching adjustment screws are already included, so you can start with the installation and fine-tuning immediately.

The cable is made from high-quality steel wire, which is particularly tensile and ensures a precise pressure point when braking. The black casing is coated on the inside to keep friction as low as possible. This means for you: maximum braking force with minimal effort on the lever. Whether you ride an original Puch Maxi S or N, this cable pull provides you with the quality you need for everyday use in road traffic.

Installation Tips: Carefully thread the cable pull through the guide on the handlebars and the fork tube. Make sure that the cable is laid out in large radii to avoid unnecessary friction or pinching while steering. With the included adjustment screws, you can perfectly set the play at the brake lever. We recommend adjusting the lever so that the brake engages strongly after about one-third of the lever travel. After installation, be sure to check multiple times while stationary that everything is secure.

Care Instructions: To ensure a consistently smooth function, you can add a few drops of acid-free oil or special cable spray into the casing before installation. However, avoid thick grease, as it can harden over time and make the cable stiff. Regularly check the brake cable for kinks or damage to the outer casing to prevent rust formation inside.

Dimensions:
Total length: 113cm
Length of cable casing: 98cm

This item fits, among others, the following models:
- Puch Maxi-N
- Puch Maxi-S
- Puch Supermaxi