Original Piaggio intake flange for Ciao / SI (catalytic converter models)

Are you looking for the perfect solution to get your moped running reliably and authentically again? This Original Piaggio intake flange has been specifically developed for the Ciao and SI models with catalytic converter carburetor. As a direct replacement part from the manufacturer, it guarantees you absolute fit and the quality your cult moped deserves.

The flange serves as a crucial connection between the carburetor and engine housing. Since it often becomes brittle or shrinks due to heat or vibrations in older models, timely replacement is important to avoid air leaks and ensure clean combustion.

Your advantages at a glance:

• Original quality: Precisely fitting original part from Piaggio for maximum durability.

• Optimal sealing: Prevents the intake of secondary air and stabilizes idle speed.

• Plug & Play: Easy replacement for the old, worn part.

• Specific design: Specifically tailored to the geometry of the catalytic converter carburetors.

Installation & maintenance tips

To ensure everything goes smoothly during installation, we have a few tricks for you:

1. Cleanliness is key: Before installing the new flange, thoroughly clean the intake port on the engine housing of old residues or grease.

2. Check the fit: Ensure the flange sits completely flat. An angled fit can lead to leaks.

3. Careful tightening: Tighten the carburetor clamp screw evenly. Excessive force can damage or deform the new flange.

4. Check: After the first test ride with the engine running, briefly spray some brake cleaner on the connection. If the RPM does not change, everything is perfectly sealed!