Flywheel / Stator Replica for Piaggio Ciao, SI and Co. – Full Power for Your Ignition

Get your moped back on track with this high-quality flywheel (stator) as a replica. It has been specifically developed for the classic models Piaggio Ciao, SI, Bravo, Boxer, Grillo, and Gilera that feature a contact ignition (breaker ignition). The flywheel is a crucial component for power generation and the ignition spark – precise craftsmanship is key for a smoothly running engine.

This replica impresses with its fit and ensures reliable magnetic induction. Whether you're restoring an old engine or need to replace a defective original part: with this flywheel, you ensure that your breaker opens and closes at just the right moment.

Tips for Installation and Maintenance

• Clean the cone: Before you place the new flywheel onto the crankshaft, both the cone of the shaft and the receptacle in the flywheel should be completely grease-free and clean. It’s best to use some brake cleaner for this.

• Check the key: Be sure to check the condition of your taper key (half-moon key). If it is worn out, the ignition timing may adjust or the flywheel may come loose.

• Use a puller: Always use the appropriate flywheel puller for removing the old flywheel. Strikes with a hammer can damage the magnets inside or bend the crankshaft.

• Contact gap: Use the opening in the flywheel to optimally set the breaker contact (usually 0.4 mm).